Firmly squeeze the applicator and attach the tag. With the tag and button in position on the applicator, place the tag on the inner flat surface in the center of the ear (middle third of ear).Use only the Allflex Tagging System (Total Tagger or Retractomatic Tagger) to apply Patriot and Commando Tags.The point of the male button must be properly aligned with the hole in the tag for successful application.īEFORE YOU APPLY THE TAG, PARTIALLY SQUEEZE THE TAGGER TOGETHER TO INSURE THE TIP OF THE STUD IS ALIGNED WITH HOLE IN THE TAG PANEL.The slot allows the expansion of the base of the insert as the button (rivet or stud) is forced through it.The retention of the tag is not affected by a break/crack to this area of the insert. The area of the collar above the slit is designed to break or crack when the stress of application exceeds the tolerances of the material. The hard plastic insert is designed with a collar or rim around the top and a slit on one side.If it becomes dislodged during transportation/handling, replace the insert in the collar before putting the tag in the applicator. The insert must be properly seated in the upright, circular collar of the tag.The presence of the hard plastic insert (retainer, clip, interlocking device, etc) is absolutely necessary for proper retention, due to the softness of the highly loaded matrix.Guidelines for Applying Patriot and Commando Insecticide Ear Tags
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |